StealthChanger Umbilical NO DEPINNING

This is an umbilical mount for a Voron 2.4 Rev D kit from LDO Motors. It uses 1mm steel wire for an umbilical.

It does NOT require you to remove the cable connectors on the Nitehawk, like a commercial cable gland would.

I printed it from PETG with 20% gyroid infill.

It requires M3 hardware. Use what makes sense. One screw on the side holds the umbilical mount in place and the other two attach the wire plate. Bend the end of the wire and screw it down, matching the channel in the little part. Use zipties in whatever way you want to bundle everything. The image shows the jacket off, but you probably will want to bundle that too. You probably also want to bundle the wire internally to the umbilical with a couple more zipties along the length.

This is only the toolhead umbilical mount. You will need a rear plate to go with it… https://makerworld.com/en/models/841467

MOUNT ARM REMIXED FROM:

https://www.printables.com/model/233008-voron-stealthburner-umbilical-cable-gland-mount/files