Search models, users, collections, and posts
5x Speed Changer
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
1 plate
Open in Bambu Studio
Boost
2
6
0
0
3
0
Released
Description
Content has been automatically translated.
A 5x speed changer, it is recommended to use self-tapping screws of approximately M3.5 and 8-20mm in length (four) for installation.
The radius of the circumscribed circle of the horizontal cross-section of the cuboid shaft is 4mm. According to my test, for PETG material, a hollow with a circumscribed circle radius of 4.15~4.2mm can be smoothly inserted (this project uses 4.2mm).
The module of the gear is 2, the tooth height coefficient is 1, the backlash coefficient is 0.25, and the pressure angle is 20°.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)