Remeshok Chetki beaver tail sleeve

If you have Aroundsquare Remeshok Chetki and you want to try out if the beaver tails are for you, you can print these to try out.
I have the regular titanium version, but this should also work on the other metals and delrin versions.

Print suggestions

Layer height: 0.08
Material: PLA/PETG
Layer width: 0.42 (design is based on that layer width)

Print orientation: print on the flat side

Supports: No

Seam: Set to back so it will land on the thinnest side of the sleeve, making it almost invisible.

Assembly

Remove the string
Fit the sleeve on your end pieces.
I left some tolerance around the end piece for different printers to still be able print this.
If your printer is very accurate you might need to put one or a couple of layers of tape on the top and bottom of the end piece for a snug fit. Do this on both sides so the bead stays in the middle of the sleeve.
Then restring. You might need to remove two middle beads from your Chetki, because the beaver tails add quite some length.

Rights

If you want to buy these beautiful Chetki or other skill toys, visit https://www.aroundsquare.com/ 
I'm not affiliated with Aroundsquare and all rights of the Chetki are with them.