Search models, users, collections, and posts
Cheese candle mold
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
316
764
11
6
281
142
Released
Bill of Materials
List other parts
- Wick x 1:
- Beewax x 1:
Description
Cheese candle mold. Assembles from four parts + two brackets to hold it in place.
Recommended to be printed from ABS.
Casting instructions:
- Id recommend to heat the beewax (other wax types might have different temperatures) to 85-90 degree celsius. Hotter wax might start bonding to plastic, colder will leave visible wax seams when pouring.
- Original or smaller molds dont require anything to be done with assembly seams, however if you scale it up, id recommend to mask the seams with paper tape (that you use for painting). It will prevent any leak thru.
- Install the vick, and pour the vax. Leave it to sit for 10 mins, if necessary add some vax again. Afterwards i put it in the fridge for 10-15 mins, and later remove the bottom and top covers and put it back in the fridge.
- After a while mold should pop off itself, due to thermal contraction.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (11)