ImpressArt Set - Made for Dewalt Tough Case+

Insert is made to fit DeWalt ToughCase+ DWAN2190. Lowes - $8.50.

And ImpressArt Metal Stamp kits -

The ImpressArt Hammer is too big to fit -

So I used this one from Michaels -

All the parts

I lost the orange top from the set of 9 numbers so I improvised -

Fits snug -

Notes -

This project is just the insert, and not the case itself.

Printed in Hatchbox PETG - Dark Yellow, with .6mm nozzle and .3 layer height (link below)

Raised lettering would be nicer with .4mm nozzle.

Infill set to 20% to create nicer ‘bottom’ to superglue insets (pics below)

The insert is 158mm x 188mm so no A-1 Version.

Reference -

I did a review comparing best DeWalt yellow filament - check it out on Reddit if you like - Closest DeWalt Yellow Filament