TUPAC HUEFORGE 149x150

I rendered a grayscale portrait of Tupac using Hueforge software.

Print with 100% infill, a 0.08mm layer height, and a 0.16mm base layer.

The model measures 149.44 x 150 mm.

Higher layer heights are permissible, provided they remain below the minimum depth of 0.48 mm.
The maximum depth is 2.2 mm, while the actual depth is 1.4 mm.

Filaments Used:

• Bambu Lab PLA Basic Black, Transmission Distance: 0.6
• Bambu Lab PLA Basic Gray, Transmission Distance: 2
• Bambu Lab PLA Basic Jade White, Transmission Distance: 5

This print employs three distinct filaments.

Filament Swap Instructions:
Begin with Black.
At layer #8 (0.72 mm), switch to Gray.
At layer #11 (0.96 mm), switch to Jade White for the remainder.

<------------------------------------------------------------------------------------------------------------------------>

I created a painting with Hueforge software in grayscale representing a photo of Tupac.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 149.44x150mm in size

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 2.2mm and the Actual Depth is 1.4mm

Filaments Used:

• PLA BambuLab Basic Black Transmission Distance: 0.6
• PLA BambuLab Basic Gray Transmission Distance: 2
• PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 3 unique filaments

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Gray

At layer #11 (0.96mm) swap to Jade White for the rest.