Search models, users, collections, and posts
Lattepanda case with stand or vesa mount
IP Report
Print Profile(2)
0.2mm layer, 6 walls, 25% infill - Vertical stand
Designer
1.7 h
1 plate
0.2mm layer, 6 walls, 25% infill - Vesa-100
Designer
2 h
2 plates
Open in Bambu Studio
Boost
5
4
2
0
34
25
Released
Description
The original model is this, I had to adapt the hole for the audio connector, sd card, usb 3.0 and those for the strips.
This is because they were all too narrow and my lattepanda could not fit in.
Furthermore, in addition to the vertical support already present in the original model,
I added the vesa-100 support to be able to screw the case directly to a monitor.
Note that the bottom of the case for the vesa-100 has larger holes to facilitate assembly.
To assemble the case you need different screws depending on the chosen configuration.
- For the case without supports you need 4 screws of type M3*12 .
- For the case with the vertical support you need 2 screws of type M3*12, 2 screws of type M3*25 and 2 nuts.
- For the case with the vesa-100 support you need 4 screws of type M3*20.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)