Skadis Ryobi Charger Small (63mm)

A remix of pntzasyx charger mount that is designed for the smaller Ryobi One+ battery charger. This is sized to fit the smaller charger with the 63mm mounting holes on the back (see the picture).

The pegs are separate from the body to allow printing with no supports. They are a tight fit so might need a little tap with a hammer to fully seat them. Note the orientation of the pegs in the schematic. Large pegs at the top; small at the bottom. For the small pegs, the longer half fits in the body, leaving the smaller half sticking out.

I've added a channel in the back to hold the cord and route it downwards when installed on your Skadis.

Please let me know if you have any feedback on issues or suggested improvements!