WPL C74 (1:10 Suzuki Samurai/Jimny) Fender Flares
Print Profile(0)
Description
These are fender flares for WPL C74 body. You need to cut the body - templates for this are included.
Adds about 23mm of width to each side and makes the wheel opening bigger to acomodate tires around 100mm while keeping it reasonably low.
1) cut the body by included templates and clean the edge
2) Try snaping the flare on, the body goes inside the slots in flares, and sand down the cut if needed until it fits. Depends on your cuts.
3) take the flare of, drip CA glue inside the slot in flare and snap back to the body
I made them for my icelandic samurai project and you can use them for whatever you want to build now :)
Print them laying on the inner edge, its made flat for that. Use supports inside the slots - might be harder to take them out as the slot is tight.
Mirror the flares for other side of vehicle.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)