Search models, users, collections, and posts
Bentwood Vertical 63 dosing cup support
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
1.5 h
2 plates
Open in Bambu Studio
Boost
2
2
0
0
4
2
Released
Description
I created this to lift the Acaia Medium dosing cup up to the spout of the Bentwood coffee grinder. Grounds fall from high heaven and make a mess, so this was meant to help fix that. It fits the Acaia Medium dosing cup and Weber Workshops Blind shaker, and anything else of similar size.
Created to fit on an A1 Mini print bed, use little filament, and be quick. Legs are best printed on their side.
The centering disk has a cutout for 3M adhesive tape. Once the stand is in place, adhere the disk to keep the stand from sliding around.
The cup base has three holes for the supports, but the holes for the back two support legs are closer together. Make sure it is orient properly. Nothing should be difficult to assemble.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)