Starship 33 Block 2 (1:100) with Tiles
Print Profile(5)
Description
This is an enhanced 1:100 scale model of SpaceX's Starship 33,
a highly detailed model including tiles, resulting in a large file size.
Approximate print time for all parts: 23 hours.
Materials used: Bambu PLA Basic Black
Sunlu PLA+ Silver
Assembly:
Print all parts and assemble them.
Before gluing, test the fit of all parts and determine their arrangement sequence.
It is best to start with the hull.
Then insert the engine unit from below (paying attention to the recesses), then insert the engine shaft, again paying attention to the recesses.
Now you can assemble the tip (it's a little tricky) and connect it to the hull, then attach the previously glued flaps.
To secure the upper flaps, insert a approximately 70mm length of filament into the hinge holes and trim off the excess.
The lower flaps are inserted from the top and secured at the bottom with short M2 cylindrical screws
Matching Booster:
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (488)