Mafell Track Saw to Cen-Tec vacuum adapter

A direct replacement for the original Mafell vacuum port. This one is for use with Cen-Tec Quick-Click Vacuum Adapter. This adapter is relatively short so it can stay in place on the saw and everything still fits into the Mafell saw T-Max Systainer.

Mafell makes plunge saws for Bosch. It's possible that this adapter may also fit some Bosch track saws.

Please note that Bambu Maker wasn't able to produce a clean and correct STL export file, so the 3mf is being shared. Inside there's a negative space thyroid that smoothes the transition between two ends of the adapter.

If you have ABS filament then no changes to the model are needed, just slice it and print it with Tree Supports as the model comes. The adpter comes out clean and strong when ABS is used. Prints in two hours, and uses about 38g of filament. For a proper seal add a rubber O-ring in the same manner as it's installed on the original Mafell exhaust port.

This is my first attempt at sharing a model. A boost would be very much appreciated if found this adapter useful.