Search models, users, collections, and posts
Beer Can Handle
IP Report
Print Profile(3)
0.24mm layer, 3 walls, 15% infill
Designer
2.5 h
1 plate
0.16mm layer, 3 walls, 15% infill
Designer
2.3 h
1 plate
0.2mm layer, 3 walls, 10% infill, slower prints
4.4 h
1 plate
Open in Bambu Studio
Boost
82
242
12
4
257
164
Released
Description
holder for your can of beer, coke or any soda. it holds up great. ideal if the can is too cold.
it is easy to print, it could have been done without the supports, but I preferred to put the supports in the handle.
Remember that each can can be a little different in diameter, so if the can is too tight, use sandpaper and make the hole a little bigger. if it is too loose, use an insert made of paper, for example.
layer 0.24
3 perimeters
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (12)