StarGate Infinity Mirror - Anycubic Kit

I've recreated this model to be printed with the Bambulab using the Star Tunnel AM022 kit from Anycubic.

Anycubic LED Star Tunnel Kit: Create Your Own Cosmic Wonderland!

STEP 1: Create the stairs as shown in the photos.

STEP 2: Pass the cable through the hole, and inside, create a spiral with the LEDs.

STEP 3: Insert the mirror (B) into the back piece. (Be careful, it might require a bit of pressure. It needs to fit well.)

STEP 4: Insert the mirror (A) into the piece with the LED spiral. It might require a bit of pressure. The A2 side should face outward.

Once completed, close with the front part and you're done! Have fun!

-- PRINTING PROBLEMS --

I know how frustrating it can be to have problems during a print, and I’m happy to receive constructive criticism or suggestions about the model, but please always calibrate the flow and if you have adhesion problems, try using the brim or a gripper. All these fails are not due to the model.
All my files are tested before being published and the print profile with which I succeed is the one I publish.
Thank you very much for your understanding and happy printing to everyone!