Search models, users, collections, and posts
Figure Print Profile 0.08mm Layer Height Version
IP Report
Print Profile(1)
0.08mm layer, 5 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
16
42
4
3
86
22
Released
Description
Content has been automatically translated.
Figure print profile 0.08mm layer height. This is the most satisfactory version after seven or eight adjustments. The printing effect is shown in the image above. The test filament used was Bambu PLA Matte White and P-brand Matte White. Other filaments have not been tested. You can print the built-in model to test them. Different filaments have different shrinkage rates.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)