Sony WF-1000XM5 holder for Tesla Wireless Charger

This is a holder for a Sony WF-1000XM5 with a silicone case for use on a Tesla wireless charger. Some dimensions were based on (https://makerworld.com/en/models/193020?from=search#profileId-213407) which was based on (https://www.printables.com/@ForestKatsch_154590). It can be rotated upside down in case for some reason that one side does not activate the wireless charging. I tested this model on my 2024 Model Y on both orientations, and both work. I cleaned it up and removed some unnecessary parts so it does not use too much filament. I tried it without the silicone case and it still worked just fine.

Would suggest a wall thickness of 4 or 5. Don't use PLA, it will melt if it gets hard enough. Go for PETG, or if it really gets hot where you are ABS/ASA/PC.