Search models, users, collections, and posts
Welding Helmet Hook
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 20% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
576
1756
125
77
1.7 k
1.3 k
Released
Description
Normal story…i didn't find a design i liked so i made my own welding helmet hook. Has a nice round shape for the headband with a 45 degree chamfer on the end so it can print without supports. I printed the 6mm thick one, but made a 3mm version for folks that may not need as much strength.
Recommended print settings:
2 or more outer layers
2 top and 2 bottom layers
20-30% infill (gyroid)
PLA worked well, full speed on the A1
Orient screw hole side facing down
I used Draft layer height but standard is good too.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (125)