Lian Li A4 H20 Vertical stand

Vertical stand for Lian Li A4-H2O

Vertical stand for the A4-H2O featuring rubber feet, better airflow and a reduced footprint on your desk.

The model is easy to print but i would recommend using at least PETG since with PLA you might experience some creep, but your milage may vary.

V2 version available: https://makerworld.com/en/models/1715218-lian-li-a4-h20-vertical-stand-v2#profileId-1820408 

Instructions:

1. Unplug all the wires from the PC.
2. Turn the case over and unscrew the rubber feet connected with four screws.
3. Transfer the rubber feet to the bottom of the stand using the existing screws.
4. Run the cables through the stand using the hole on the backside.
5. Plug them into the PC again.
6. Push the computer inside the stand and turn it over so that it stands on the rubber feet you transferred before.
7. DONE!