Search models, users, collections, and posts
Drill Guide for Proline caps & Arrma 6s posts
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
3
6
0
0
8
3
Released
Description
Boost Me (for free)
Please leave a Boost if you like the print, it helps out to offset the cost of developing new models, and it's a free way for you to show your support for the models I make!
This is a drill guide to use the stock body posts on Arrma 6s RC cars. Slip the guide over your existing body post, and use a 9/64" drill bit to make a pilot hole for the Proline studs or buy 4x16mm Socket Set Screws, Cup Point and maybe some M4x6x6 Thread Heat Set Insert and make your own. Either way, your choice.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)