Snake skin Bookmars set HueForge

If you dont want a hole on the bookmark, so remove the negative part in project, before final print.

For creation used HueForge v0.8.0 to create the model.

All models are size 50x125mm. Do NOT adjust the thickness (Z) in your slicer! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

Nozzle: 0.4 You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2mm and the Actual Depth is 2.1mm

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used (for the whole set):
PLA Elegoo + Black Transmission Distance: 0.3

PLA Sunlu META Grey Transmission Distance: 3

PLA Devil design Dark Brown Transmission Distance: 0.8
PLA Bambulab Basic Brown Transmission Distance: 3

PLA Aurapol Beige Transmission Distance: 2.4
PLA Elegoo + Yellow Transmission Distance: 4
PLA Elegoo + White Transmission Distance: 8.9

This print uses 7 unique filaments

Swap Instructions:

Brown-orange bookmartk (left on the photo)

Start with Black
At layer #11 (0.96mm) swap to Brown
At layer #15 (1.28mm) swap to Yellow
At layer #19 (1.44mm) swap to White for the rest.
 

Dark brown bookmark (in the middle of the photo)

Start with Black
At layer #9 (0.8mm) swap to Dark Brown
At layer #11 (0.96mm) swap to Beige
At layer #12 (1.04mm) swap to White for the rest.
 

B&W bookmark (right on the photo)

Start with Black
At layer #8 (0.72mm) swap to Grey
At layer #15 (1.28mm) swap to White for the rest.
 

Added second set, color description in profile.

Please share your prints.