HY300pro projector stand

You can place your projector on any table you want quickly and easily.

Support for table or board for HY300pro projector, support table thickness between 60mm and 10mm.

You will only need an M5 nut and an M5 to 1/4 adapter for assembly, which I will leave you below where to purchase it.

M5 to 1/4 Adapter Link:

https://www.amazon.es/dp/B0CCS1T6LK?ref=ppx_yo2ov_dt_b_fed_asin_title

Once the support is assembled, you will only have to rotate the projector in the position you want and leave it fixed by tightening the nut on the back.

By using a 1/4 universal nut, you can use the mount for any other device that has the same thread.

For printing, it is recommended to use a high layer density (more than 50%) in the following orientation. For the nut, two models have been left, one to insert the M5 nut during printing or another open for later placement. It is recommended to use more technical materials than basic PLA such as reinforced PLA, Tough PLA or PETG.