Sunlu S2 Clip-On Filament Outlet - Free 3D Print Model

Search models, users, collections, and posts

Zalachenko

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

21 min

1 plate

4.6(10)

Open in Bambu Studio

Boost

257

382

254

Released

Description

Description:

Design features two main components: the main outlet and the bottom wedge. The main outlet efficiently directs the filament tangentially to the spool, while the bottom wedge ensures a secure and stable hold. Outlet enables you to use it as horizontal or vertical outlet. Assemble effortlessly and upgrade your filament drying process with this practical, tape-free solution.

Installation:

Attach the main outlet to the dryer's exit port. You can use it as horizontal or vertical outlet.
Secure it in place with the bottom wedge for a stable fit. Use pliers as there is little space
Enjoy a reliable and neat filament guiding system.

Print setting recomendations:

PETG, ABS, ASA
0.4 mm nozzle
3 perimeters
4 top and bottom layers
100% infill

Comment & Rating (37)

@dryfiredude

Exactly what I needed. quick and easy print too! thanks

@Killdozer666

The print profile is no longer public

It works! Printed on P1S with PLA. Installed as instructed, with the addition of hot glue to the underside to make it sturdy. I heat threaded the fitting into the print. Filament: Flashforge PLA Burnt Titanium

@sp66

Print Profile

0.2mm layer, 2 walls, 15% infill

just waiting for the tube now but did print Perfect and fit Perfect

@davschn

The print profile is no longer public

Fits okay but is a bit loose. Would have prefered a tighter fit. Everything else printed fine, supports were easy to remove.

@nickeelen

The print profile is no longer public

@FaidaTega

The print profile is no longer public

@matths

So, print worked nice, but my Sunlu Filament Dryer S2 does have smaller holes than this outlet can handle, I am sorry, I can't make it fit without destroying it. Maybe Sunlu did change the diameter of that hole?

The designer has replied

@matths

Sorry, turned out to be my fault. I have the white/transparent Sunlu S2 and there's a mini transparent plastic tube in the hole which one needs to remove before all these models work. I did not know that, so not a problem of your model.

@Zalachenko

They might. I have no way of verifying it as I dont own S2 anymore.

@dryfiredude

The print profile is no longer public

Print quality wasn’t as good as anything else I have printed. The design wobbled a lot, and wasn’t easy to get the filament out of the dryer and into the ptfe. I swapped this out with one that I hot glued in place and allowed PTFE to go all the way into the dryer. I don’t have a picture anymore because it broke when my dryer fell over. That is not a fault of the design or profile though, that was an issue with my dryer setup. had the design been secure and easy to load, I would have reprinted.