Cat angry face 2 filament painting

My cat Bran will be immortal with his angry face. 🐱

Prints to about 5cm x 4cm x 2mm. It's going to be thin, but still strong enough to feel good in hand.

If you have AMS, just print using the default profile.

If no AMS and you are prepared to manually swap filament, use the following guide:

• Filaments Used:
  PLA PolyLite Black Transmission Distance: 0.3
  PLA BambuLab Basic Jade White Transmission Distance: 5
  PLA BambuLab Matte Marine Blue Transmission Distance: 2
  PLA BambuLab Matte Mandarin Orange Transmission Distance: 3
  
• Swap Instructions:
  Start with Black
  At layer #15 (1.28mm) swap to Jade White
  At layer #17 (1.44mm) swap to Marine Blue
  At layer #18 (1.52mm) swap to Mandarin Orange
  At layer #24 (2mm) swap to Jade White for the rest.