Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
5
8
1
0
33
27
Released
Bill of Materials
Bambu Filaments
Select all
Description
I wanted to make some small, easily removable cover for BP-U battery packs I use for my SONY FS-7 camera.
After few iterations I decided to go with this design. It is easily attachable and can be as easily removed with one hand which is good when you are in rush on set. They're also lightweight and easily printable, so when lost it is easily replaceable.
I recommend printing as shown on image, model is designed with some tolerances in mind. When unable to install right after printing, just clean bottom side of the clamps with a sharp knife or scalpel.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)