Leroy Merlin's Lexman Power Strip holder

This two-pieces power strip holder was made to attach it to a wooden piece of furniture as there was no fixture in the power strip to do it.

Installation

To install it both ends are to be screwed onto whatever surface you want it. Once both ends of the holder are screwed, you can slide the power strip in from the “cable end” side.

The best way I found to install it was to place the screws in the hole, slide the power strip to both sides and mark the wood with the screws themselves. Afterwards, both ends can be screwed into position.

Hardware

The hardware needed is:

• 6x3.5mm screws, any preferred length.

Holes could be enlarged by the screws themselves.