Search models, users, collections, and posts
Ramps 1.4 adaptor for ORCA Printer
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
0
0
0
0
0
Released
Description
Summary
This are two small adaptor pieces to put on the Ramps 1.4 board on your Orca printer.
Instructions
Print both pieces with support.
The parts are very tiny, use a small print setting, and ensure that the support is not too strong or it is very difficult to remove afterwards.
Mount both plates with short M3 screws on your printer ans just plug the Ramps 1.4 Kit into the Adapter.
The board itself is not fixed by screws, it holds just by pushing it into the frame.
the board holds very good, it can not fall of by mistake !
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)