Search models, users, collections, and posts
Removeable spoolholder for ORCA printer
Remixed by
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
0
0
0
0
0
0
Released
Description
Summary
Here are some nice removeable Spoolholders for your great Orca Printer :)
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
Instructions
Just print them and put them on your printer.
ensure that you printer is well tuned, they fit tight.
should fit PnP on most V40+
For V30 (and some early V40) you need to drill some holes and screws + nuts.
2x M3x10mm + nuts
2x M4x10mm + nuts
the upper part is made for 5mm teflon tube to fit in.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)