Search models, users, collections, and posts
Microbit Alligator Clip Guide
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
24
65
11
4
117
74
Released
Description
This model is inspired by https://www.thingiverse.com/thing:3026674 by TruncusEnc. The original model has some alignment issues on micro:bit v2, revealing the adjacent traces. I recreated this from scratch with better alignment, removed the edge support so the alligator clip can bite into the PCB edge notch that was added in microbit v2, and also made it less tight so it's easier to put on/off.
Print with no support.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (11)