Sovol SH2 or Comgrow SH02 Filament Dryer Riser

Found a similar model for a slightly different Sovol drier (3D Dual Drier) that almost worked, but although they look similar sizes, they aren't. This model is tweaked to fit the footprint of either the Sovol SH02 or Comgrow SH02 dual roll filament driers. It's roughly 1" high, there is additional center supports as I realized 2 spools of filament weigh in at 2Kg or 4.40 lbs, so i wanted to be sure it was safe [I have 2 cats - if you have cats, then you will understand. Dogs too. Probably any small creature that runs around controlling your life :) You will understand].

I suggest printing in PETG or ABS (if you can), but if you have some PLA + or PLA Pro, that may work. You want heat resistance! No support needed, pretty straight print.