Search models, users, collections, and posts
Renault Clio 3 O-Ring Wheel Cap with Logo
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
65
101
1
2
117
43
Released
Bill of Materials
List other parts
- R32_O-ring x 1: 3.5x50mm
Description
I designed this wheel/rim cap for my clio 3 to replace the original caps on the rims which looked boring, at least to me. I made logo as a separate part so the whole thing has a bit of a 3D look with logo slightly protruding.
When printed remove supports from wheel caps, push the logo in the cap with ridged surface on the inside, apply some super glue in the little holes on the inner side of the cap and put on R32 rubber o-rings (1 for each cap), which tightly hold the cap in the rim.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)