Santa's little helper tape dispenser

Santa's little helper will help Santa (you), wrap the presents faster.

Print with normal PLA or PETG. Do not use PLA silk as it is too stiff and brittle.

NO MORE:……………………………………………

Having pieces of tape stuck on your fingers

Sticking tape on the table edges

This tool will allow you to have the tape ready when wrapping the presents. 

Easy to print and assemble.

Steps to assemble:

Step1:

Allign the 3 slidding parts. Smallest in front.

Step 2:

Interlock the 3 slidding parts together.

Step 3:

Push the 3 parts together.

Step 4:

Slide the 3 slidder parts into the main body.

Step 5:

Add glue to the santa hats. Only add glue to the small extrusion and the flat surface. DO NOT add

any glue to the long extrusion as shown in the image.

Step 6:

Add the santa hats to the main green body. Note that the tip of the hat must point to the front of the green body on both sides.

Step 7:

Slide the tape over the roler.

Step 8:

Slide the roller in at the back and stick the tape over the edge of the main body and the 3 sliders

to hold the sliders in position

To use Santa's helper, lift the tape and slide the 3 sliders out until the lock. Pull the tape over the sliders and push down on them over the sliders to make it stick to the sliders.

Use a scissor to cut the tape between the sliders and wrap your presents.

Repeat the process if needed.

When done, push the sliders back and fold the tape ends over the sliders.

Happy wrapping