Lord of the Rings lamp IKEA Tarnaby Conversion

This is a conversion kit for Ikea table Lamp TÄRNABY (603.238.94 article)

"They're taking the hobbit to Isengard"

IKEA Description: Small and easy to place anywhere you want to bring some cosiness and mood light into your home.

If you want to dim the light, just turn the knob.

By dimming the lighting, you change the mood in the room.

My Description after redesign of the lampshade: Small and easy to capture Sauron attention or to launch Saruman from a considerable height.

If you want to crush all the light forces, just turn the knob. By dimming the lighting, you ensure your control over Arda's races.

DO NOT FORGET TO BUY ONLY DIMMABLE E14 LED LIGHTS 
DO NOT USE WITH NON-LED LIGHT OR IT WILL BURN IN NO TIME

PRINTING/ASSEMBLY

1. Print all parts laying on the sheet
2. One of the 8 bastions is shorter, it is meant to be placed over the dimmer knob
3. You can use glue or not, depending on how tight it is assembled (I didn't used glue but I applied some force to keep the joints even though I used 0,1mm tolerance they stay super tight).
4. First print the Tarnaby ring, then joint one of the bastions, then all the rings, then match all the bastions respecting the joints (it's straightforward once you print them). I suggest

5. The lampshade ring: you can choose between capped or with hole, I used one with hole because of the led light height. I used a Green Glow PLA in vase mode to keep a “Morgul” design once it's put off. There are two version, one 0.6 mm and one 0.4mm, depending on your nozzle size. You can chose also another kind of PLA or a clear PETG if you like something special, up to you.

    

SHARE IN COMMENTS YOUR PRINT