Search models, users, collections, and posts
Casting mold for 230V LED strip
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
24
62
1
0
19
6
Released
Description
Content has been automatically translated.
A casting mold for 230V LED strips with dimensions of about 10x5mm. The block has outer dimensions of 20x10x6mm
Unfortunately, the original connector block from the strip manufacturer was too large for the intended ALU profile. However, for safety reasons, as well as to prevent the wires from tearing off the strip, a strain relief was necessary for soldering.
The casting mold is simply placed around the strip and the soldered wires and then poured out, for example, with transparent silicone.
Work on 230V should only be carried out by a qualified electrician! There is a risk of death!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)