Search models, users, collections, and posts
LittleBigPlanet Pod
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.7 h
13 plates
Open in Bambu Studio
Boost
15
32
3
5
44
17
Released
Description
The Pod, ripped directly from the game files of LittleBigPlanet and adapted for 3D printing.
The only noticeable change is to the top and bottom pipes, which are now thicker and have slots for each wing/spine; otherwise it is almost intact from the game.
Each part runs a bit thin (like card), which can make it difficult to assemble. Hot glue is a must to keep it together. It may be possible to scale each flat part (spines/wings/discs) by 1.5-2, but this will also use more filament/increase weight.
The PS3 controller is the only part that requires supports, but are otherwise easy to remove.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (3)