Poolverine Textured Helmet
Print Profile(1)
Bill of Materials
Description
Compatible with both - https://makerworld.com/en/models/747428#profileId-680642
https://makerworld.com/en/models/606324#profileId-531273
Sized to fit my number 3 sizing head found here - https://makerworld.com/en/models/525268
Uses 8x2mm magnets, 100 in total. - Be sure to use the magnets in the BOM as they were tested and work properly.
It took 3 tries to get the sides positioned correctly. At some angles the yellow ends up bleeding thought the black area, So do check for that when repositioning them.
How to Check - Slice the model and look around for tiny yellow bits showing though the black. You can confirm by scrolling though the layers and finding the exact layer it protrudes from. Im not sure what causes this, Maybe one of you could enlighten me in the comments ?
I tested if the Prime Tower was necessary, Printing one side with the Tower and the other without.
The Prime tower is 100% Necessary for a clean print.
I included pictures to show the results in the Profile.
Enjoy
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (72)