Melitta F85/0-102 Barista TS Bean Hopper Extension

Are you fed up with constantly refilling your Melitta Barista TS coffee machine? This hopper clips to the top of the inbuilt bean compartments, and extends them to approximately 2-3x the internal capacity. The opening at the hopper's top reuses the bean compartment's standard cover.

The clearance needed above the coffee machine is approximately 90mm, and the hopper doesn't block any of the other standard ports (the water hatch or ground coffee flap both open unhindered).

NOTE: The print profile provided prints in 4 parts with Bambu Studio-generated snap fittings. If preferable, I've attached the original STL to allow printing as a single part, although this requires about 60% more filament due to support requirements.