Search models, users, collections, and posts
Drink coasters with holder
IP Report
Print Profile(2)
Coaster holder + 6 coasters
Designer
1.8 h
2 plates
0.12mm layer, 3 walls, 15% infill
2.2 h
4 plates
Open in Bambu Studio
Boost
169
414
38
13
589
313
Released
Description
Needed some drink coasters for my living room so I created these.
You can modify the pattern on all coasters by changing the “Sparse infill pattern”, you find this in the Strength tab in Bambu Studio.
Each coaster is modifiable and takes about 2 hours to print it all.
Coasters are 92mm wide and 3mm thick.
Coaster holder is 95mm wide, 21mm high.
It fits 6 coasters in the holder.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (38)