Search models, users, collections, and posts
BIFRC spot welder snap-fit case
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Open in Bambu Studio
Boost
5
4
1
0
7
5
Released
Description
This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid.
I used a bit of hotglue to cover the hole for the LED. The light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) )
The pcb doesn't rattle inside the case and is kept tighly in its position.
Print Settings
Printer Brand:
Ultimaker
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
25%
Filament:Colorfabb PLA black and red
Notes:
I used Cura for slicing. Printed with tree support, 0.1mm layer and 25% infill.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (1)