Search models, users, collections, and posts
Blower Extender for LMM 30A Hand Blower
IP Report
Print Profile(1)
0.6mm nozzle, 0.3mm layer, 4 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
22
57
0
0
77
20
Released
Description
This is an nozzle extender for use on LMM 30A Hand Blowers/Jets. Glue a magnet into the bottom of it to hold the nozzle on just like that one that comes stock with the blower.
Due to heat issues when air is blowing through the nozzle, I would suggest using PETg, ABS, or ASA for the nozzle. Some PLAs on extended use get a bit soft.
Print standing up with supports from build plate only for the magnet hole.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)