Apple MagSafe Single/Duo Charger

*desk charger for Apple watch and for Phones using Apple magsafe chargers. ( phone charger diameter of 56mm )
   There is another user profile for the bigger 60.5mm charger. ( thank you Radiateurs )

*designed to hide completely the cables.

*you can charge two devices at the same time.

*the phone magsafe is rotating with magnetic snap in two positions. You can also charge your airpods on it.

*no supports are needed for printing. 

*simple to print and assemble.

*no hardware is needed.

*I have added an optional desk tray (profile) in which the charger fits.

*optionally, use 3 magnets of  6x2mm so that the rotating movement of the phone charger has a snap-in action for easy and precise movement in both positions.

*optionally, use some Adhesive Foam Sponge Strip Roll on the bottom, so that the support is not moving on your desk.

Assembly:

*Please be sure to insert the magnets with correct orientation. The top moving part will contain two magnets which both should attract the 3rd magnet found on the middle part.

*I wanted this model to not put much strain on the magsafe cables when rotating a lot the top part, so one of the gray clip is especially created to hold better the cable where it exits the phone magsafe charger.

*Please check bellow image for exploded part view:

*please route the watch cable through this clip, so that the phone cable doesn't hit the watch cable while moving.

Please also check my new Vertical laptop stand: https://makerworld.com/en/models/783520#profileId-720958

You can check all my models → here.
Or check my collection of my best models:

https://makerworld.com/en/collections/1921582-my-best-models