Spartan hoplite I. HueForge

Source AI image - community public gallery.
Then used HueForge v0.7.4 to create the model.

Size 150x200mm. Do NOT adjust the thickness (Z) in your slicer! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

Nozzle: 0.4
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used:
PLA+ Elegoo Black Transmission Distance: 0.1
PLA+ Elegoo Space Gray Transmission Distance: 2.4
PLA Aurapol Beige Transmission Distance: 2.4
PLA+ Elegoo White Transmission Distance: 8.6
This print uses 4 unique filaments.

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Beige
At layer #19 (1.6mm) swap to White for the rest.
 

Please share your prints.