Search models, users, collections, and posts
MJX 16208 and similar redesigned arms
IP Report
Print Profile(3)
TPU for AMS - recommended 0.2mm layer, 6 walls, 100% infill
Designer
3 h
1 plate
TPU 0.2mm layer, 2 walls, 100% infill, good layer adhesion
Designer
5.4 h
1 plate
PETG 0.2mm layer, 5 walls, 80% infill
3.1 h
1 plate
Open in Bambu Studio
Boost
38
92
11
10
56
37
Released
Description
For MJX Hyper Go H16H H16E H16P 16207 16208 16209 16210 rc car.
Part Numbers:
Front swing up 16210
Front swing down 16220
Rear swing up 16240
Rear swing down 16250
Most of the measurements are the same, a bit redesigned to be more beefy, with the thought of being printed in TPU. PLA would be good too, but they will crack at some point. TPU is indestructible.
Mirror the models on Y to get the right side.
UPDATE 2: updated tolerances, after extensive testing. The black ones are the lastest version and i think its final unless i get any feedback suggestions from you guys
Enjoy
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)