Corner Bed Locator for Anycubic Kobra 2 Max w/ cable management

It is not easy to locate the bed on a 420x420 machine. I have designed this locator to fit the Anycubic Kobra 2 Max.

Note: 2 models the difference is the clearance on the side to the gantry/motor. Some machines require a narrow model which is the 2mm version.

I replaced the screws for the cable harness with M3x25mm flat head screws replacing the 16mm long screws. Then I used nuts and washers to attached. Then 2 zip ties to secure the power cable to the bed. I added a 15% lift to the cable to help prevent the cable from getting wrapped under the machine.

Warning: Test mount, make sure the locator clears the motors on the upright of the machine. If the bed is offset to much it will not clear.

Printed from PETG, 6 walls, 25% infill.