Search models, users, collections, and posts
Vertical 240mm x 25mm raditor hard drive bay mount
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill no support needed
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
2
2
0
1
9
2
Released
Description
As the InWin case is very limited in space, I have to be very creative on mounting additional radiators for the CPU water block. I assume you can change the base plate to fit whatever mounting standard you want, but I made it for the InWin S-frame case in particular.
I printed it with PLA, so if you are using other material, make sure you figure out the correct shirking factor.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)