Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 4 walls, 20% infill
Designer
2.7 h
2 plates
Open in Bambu Studio
Boost
26
127
1
1
103
67
Released
Description
The original model was perfect but I just needed to mount it in my Suncast shed instead of a wall, I took it into Fusion and added a recessed hole for the OEM Suncast screws. I also printed the Suncast Easybolt by Terrywood02 on Printables and that fit as well.
I included both orientations in the profile, both hold the blower fine and held up well to a couple of hard pulls on it. It seems like it's basically just aesthetics and different supports, minimal difference in print time/filament. I recommend printing in PETG for strength and heat resistence depending on your climate, sheds can get pretty hot in the summer months.
I plan on also doing an EGO weed wacker mount in the near future. Enjoy!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)