Shy Guy Multi faces Multi Part NO AMS

Easily buildable Shy Guy, there should be a tight enough fit from the soles of his shoes to his headband to work without glue, but his body can be glued together between layers to prevent him from coming apart if you want. I would recommend building him first becuase his shoes might fit opposite of what you originally think as the curves are suppose to be on the outside not inside.

I've remixed the original to allow more support through the body and then adjusted the eyes and mouth for a much tighter fit to allow you to assemble and change faces without glue, tight enough to hold his mask close to his body but loose enough for you to work back out if you want to change it up. His short mouth can be hard to grab so a tool to assist with grip like plyers or knife can help remove if wanted.

Both print profiles will have adaptive layer heights on faces, eyes, and some body parts to help with clean looking prints.

Support setting tip under the Support tab, scroll to Advanced section, locate Top Z Distance. Adjust this from .2 to .25 for easier support removal. Screen grab in photos. Instead of just changing the profiles I figured I would share the new tip/trick for all your print/support needs. This has minimal effect to the print surface and usually makes support removal much easier. 

There are three faces with two sets of eyes and mouth, use:

Tall eyes and tall mouth for his normal face.

Tall eyes and short mouth for his sad face.

Short eyes and short mouth for his angry face

Colors I used:

Bambu Red

Bambu Blue

Bambu Yellow

Bambu Black

Bambu White

Bambu Matte Tan

eSun Brown