Spektrum SLT2 remote base - Free 3D Print Model

Search models, users, collections, and posts

JandonBro

Hobby & DIY>RC

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

2.1 h

1 plate

4.8(21)

Open in Bambu Studio

Boost

138

332

214

Released

Description

The remote kept tipping over whenever I tried to set it down quickly. This little stand lets you prop it up securely. You'll need to wiggle it side-to-side a bit, as I made the fit very tight. Once it snaps in, it's quite snug. I used a zip tie at the base, but it's not strictly necessary due to the tight fit, just a bit more security. The battery compartment remains accessible, so once the zip tie is locked in, you're good to go. It's designed to be a "set and forget".

I printed this with a standard 0.2mm profile, using tree supports only for the large overhang. Be cautious with auto-supports, as they might interfere with the zip tie hole and be difficult to remove. Simply follow the orientation/overhangs and settings in the screenshot.

I used this design from 3Dshed, props to him because I couldn't have made this without it.

Comment & Rating (25)

@Kgood36

Printed in resin grey water washable. Nice tight fit. An man does it help with standing the remote. Also adds a good amount of weight to the radio

@user_1553819323

I like t, fits as described. I drilled a hole in the ziptie loop for a 2mm tapping screw, goes into the lower part of the handle, looks better then a ziptie ;)

@emanuele.10392

Hello, do you have the shell's STL file

Show original

@BBQ_Monte

Print Profile

0.2mm layer, 2 walls, 15% infill

It stands very securely. But the base is a bit loose without zip ties. I would like it if no zip ties were needed and it fit a bit better

(Edited)

Show original

@jasonboz56

Print Profile

0.2mm layer, 2 walls, 15% infill

printed and works well

@OpEnDuCk

Print Profile

0.2mm layer, 2 walls, 15% infill

very nice now my controller doesn’t fall over every single two seconds!!

@razoys15

Print Profile

0.2mm layer, 2 walls, 15% infill

cool

@Lomaneel

Print Profile

0.2mm layer, 2 walls, 15% infill

very practical, stabilizes the radio well, thank you

Show original

@user_1902844220

Boosted

nice base, fit very well

@Imlost

Print Profile

0.2mm layer, 2 walls, 15% infill

@tdl54

Print Profile

0.2mm layer, 2 walls, 15% infill

just what I need. now I got to print off 100 more for all my transmitters.

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.