Search models, users, collections, and posts
AW11 MR2 Dimmer Wheel / Dial
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 25% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
2
9
1
0
7
6
Released
Description
I made this to replace the dimmer wheel on the aw11.
There are three files, an extra tight fit, tight fit, and snug fit I may add more if this is too tight for some people.
Print in a stiff and heat/uv resistant material. ASA will likely be fine. Recommend using 4 walls at least.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)