Search models, users, collections, and posts
3D scan of paper DUCK
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
50 min
1 plate
Open in Bambu Studio
Boost
6
5
1
0
8
3
Released
Description
Summary
This is 3D scan of paper duck craft I made.
Now you can print it and play with it.
Two leg version was remix by Meshmixer.
Build by any type of 3D print no Additional support need.
When you going to print this, layer high 0.15~0.25mm should be fine raft is better to use and best to use over 5% infill.
Hope you will like it ;)
Enjoy ;)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)