Search models, users, collections, and posts
Arduino Jumper Wire organizer
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
764
2355
170
47
3.8 k
2.4 k
Released
Description
I improved the original model by the following:
- Adding a seperator in the middle to keep the colors from blending.
- Adding 2 more gaps to allow the last 2 colors of the commonly found jumper wire bundle to fit within this model.
- Corrected the length of the model to fit the (in my experience) most common length of the jumper wires. 18 cm.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (5)
Click to see more
Comment & Rating (170)